| Weights |
| Empty Weight | 323998 lb
| | Gross Weight | 724000.3 lb
| | Weight | 13589.3 lb
|
|---|
|
| Engine & Fuel System |
| Engine Make | 2238
| | Engine Model | SSA16 V159E-2
| | Fuel Tank | 831.1 gal
| | Fuel Type | diesel
| | Horse Power: Sae J1995 | 1492 hp
| | Number Of Cylinders | 16
| | Power Measured @ | 1900 rpm
| | Cooling System | 116.5 gal
| | Displacement | 3051.2 cu in
|
|---|
|
| Drive System |
| Emergency Brakes | Automatically applied prior to hydraulic system pressure dropping below level required to meet secondary stopping requirements.
| | Parking Brake Type | Spring-applied, hydraulically released, with speed application protection.
| | Service Brake Type | all-hydraulic actuated
| | Wheel Brake Locks | Switch-activated
| | Hoist And Steering | Dual, in-line, high pressure
|
|---|
|
| Operating Specs |
|
|
| Hydraulic System |
| Hydraulic System | 210.1 gal
| | Pumps | Two pumps, single package, end of alternator
| | Filtration | In-line replaceable elements
|
|---|
|
| Dimensions, Wheels & Tires |
| Standard Tire | 37.00 R57
| | Wheelbase | 191.61 ft in
| | Width Over Tires-Front | 22.31 ft in
| | Width Over Tires-Rear | 23.46 ft in
| | Motorised Wheels | GEB35 Traction Motors
| | Turning Radius | 446.2 ft in
| | Overall Length | 449.48 ft in
| | Overall Height | 223.43 ft in
| | Front | Wheel speed disc. Three calipers on a 1213 mm / 47.75' O.D. disc
| | Rear | Dual disc armature speed. Two 635 mm / 25' O.D. discs per side. One caliper per disc.
|
|---|
|
| Battery & Electrical System |
| Alternator | 24 volt, 250 am
| | Electric Dynamic Retarder (Max.) | 2387kW Continuously rated high-density blown grids w/retard at engine idle and reverse propulsion.
|
|---|
|
| Transmission |
| Motor Gear Box | 10.1 gal
| | Maximum Speed (Km/H) | 64.5
|
|---|
|
| Technical Specs |
| Ratio | 30.8:1
| | Control | AC Torque Control System
| | Lighting | 24 volt
| | Cranking Motors | Two/24 volt
| | Capacity - Struck | 77 yd3
| | Heaped (2:1, Sae) | 111 yd3
| | Payload | 399997.9 lb
| | Structure | Flat floor configuration
| | Canopy Sheet | 6 mm 0.24'' 690 MPa 100,000 psi tensile strength steel
| | Front Sheet | 10 mm 0.39'' 1379 MPa 200,000 psi tensile strength steel
| | Side Sheet | 8 mm 0.31'' 1379 MPa 200,000 psi tensile strength steel
| | Floor Sheet | 16 mm 0.63'' Outer 19 mm 0.75'' Center 1379 MPa 200,000 psi tensile strength steel
| | Crankcase | 59 gal
| | Hoist Cylinder | Two 3-stage dual-acting outbound cylinders and internal cushion valve, over-centre damping.
| | Relief Pressure | Hoist-17237 kPa 2,500 psi, Steering and brake-27580 kPa 4,000 psi
| | Hoist Time | Power-up loaded: 19 sec, Power-down: 10.5sec, Float-down empty: 12 sec
| | Turning Circle Diameter (Sae) | 89 ft in
| | Reservoir | 135 gal
| | Suction | Single, full flow, 100 mesh
|
|---|
|