| Weights |
| Empty Weight | 361999.1 lb
| | Gross Weight | 850649.2 lb
| | Weight | 21182.1 lb
|
|---|
|
| Engine & Fuel System |
| Engine Make | 2238
| | Engine Model | SDA16 V160
| | Fuel Tank | 831.1 gal
| | Fuel Type | diesel
| | Horse Power: Sae J1995 | 2501.1 hp
| | Number Of Cylinders | 16
| | Power Measured @ | 1900 rpm
| | Cooling System | 116.5 gal
| | Displacement | 3661.5 cu in
|
|---|
|
| Drive System |
| Emergency Brakes | Automatically applied prior to hydraulic system pressure dropping below level required to meet secondary stopping requirements.
| | Parking Brake Type | Spring-applied, hydraulically released, with speed application protection.
| | Service Brake Type | all-hydraulic actuated
| | Wheel Brake Locks | Switch-activated
| | Hoist And Steering | Dual, in-line, high pressure
|
|---|
|
| Operating Specs |
|
|
| Hydraulic System |
| Hydraulic System | 210.1 gal
| | Pumps | Tandem gear-type pump
| | Filtration | In-line replaceable elements
|
|---|
|
| Dimensions, Wheels & Tires |
| Standard Tire | 40.00R57
| | Wheelbase | 20.84 ft in
| | Width Over Tires-Front | 22.51 ft in
| | Width Over Tires-Rear | 23.92 ft in
| | Motorised Wheels | GEB25
| | Turning Radius | 46.59 ft in
| | Overall Length | 47.25 ft in
| | Overall Height | 22.58 ft in
| | Front | Wheel speed disc. Three calipers on a 1213 mm / 47.75' O.D. disc
| | Rear | Dual disc armature speed. Two 635 mm / 25' O.D. discs per side. One caliper per disc.
|
|---|
|
| Battery & Electrical System |
| Alternator | 24 volt, 140 amp
| | Electric Dynamic Retarder (Max.) | 2983kW Continuously rated high-density blown grids w/retard at engine idle and reverse propulsion.
|
|---|
|
| Transmission |
| Motor Gear Box | 10.1 gal
| | Maximum Speed (Km/H) | 64
|
|---|
|
| Technical Specs |
| Ratio | 31.875:1
| | Control | AC Torque Control System
| | Lighting | 24 volt
| | Cranking Motors | Two/24 volt
| | Capacity - Struck | 153.1 yd3
| | Heaped (2:1, Sae) | 192.3 yd3
| | Payload | 488650.2 lb
| | Structure | Flat floor configuration
| | Canopy Sheet | 5 mm 0.19'' 690 mPa 100,000 psi
| | Front Sheet | 12 mm 0.47'' 1379 mPa 200,000 psi tensile strength steel
| | Side Sheet | 8 mm 0.31'' 1379 MPa 200,000 psi tensile strength steel
| | Floor Sheet | 19 mm 0.75'' 1379 mPa 200,000 psi tensile strength steel (two-piece)
| | Crankcase | 59 gal
| | Hoist Cylinder | Two 3-stage dual-acting outbound cylinders and internal cushion valve, over-centre damping.
| | Relief Pressure | Hoist-17240 kPa 2,500 psi, Steering and brake-27580 kPa 4,000 psi
| | Hoist Time | Power-up loaded: 21 sec, Power-down: 16 sec, Float-down empty: 17 sec
| | Turning Circle Diameter (Sae) | 93 ft in
| | Reservoir | 238 gal
| | Suction | Single, full flow, 100 mesh
|
|---|
|