| Weights |
|---|
| Operating Weight | 116362 lb
|
|---|
| Operating Weight - High Lift | 119618 lb
|
|---|
| Operating Weight - Standard | 116362 lb
|
|---|
|
| Boom / Stick / Bucket |
|---|
| Bucket Capacity Range | 4.7-13 m3 (6.2-17 yd3)
|
|---|
| Bucket Capacities | 4.7-13 m3 (6.2-17 yd3)
|
|---|
|
| Engine & Fuel System |
|---|
| Engine Crankcase | 16 gal
|
|---|
| Engine Model | Cat C18 ACERT
|
|---|
| Diesel Exhaust Fluid Tank | 8.7 gal
|
|---|
| Fuel Tank | 147 gal
|
|---|
| Gross Power - Iso 14396 | 580 hp
|
|---|
| Peak Torque @ (Speed) - Sae J1995 | 2104 lb ft
|
|---|
| Torque Rise | 58%
|
|---|
| Net Power | 541 hp
|
|---|
| Net Power - Sae J1349 | 541 hp
|
|---|
| Emissions | U.S. EPA Tier 4 Final/EU Stage IV
|
|---|
| Cooling System - Jacket Water | 30 gal
|
|---|
| Cooling Systems - Power Train | 8 gal
|
|---|
| Displacement | 1105 cu in
|
|---|
|
| Drive System |
|---|
| Brakes | ISO 3450:2011
|
|---|
| Steering | ISO 5010:2007
|
|---|
| Steering Cut Off Pressure | 4351 psi
|
|---|
| Steering System - Circuit | Pilot, load sensing
|
|---|
| Steering System - Pump | Piston, variable displacement
|
|---|
|
| Hydraulic System |
|---|
| Total Hydraulic Cycle Time | 18.2 s
|
|---|
| Lift Cylinder - Bore | 8.7 in
|
|---|
| Lift Cylinder - Stroke | 41.3 in
|
|---|
| Lift/Tilt System - Pump | Variable displacement piston
|
|---|
|
| Dimensions, Wheels & Tires |
|---|
| Clearance At Maximum Lift | 11.3 ft in
|
|---|
| Ground To Bumper Clearance | 3.1 ft in
|
|---|
| Maximum Overall Length | 40 ft in
|
|---|
| Wheel Base | 14.9 ft in
|
|---|
| Front | Fixed
|
|---|
| Rear | Trunnion
|
|---|
| Ground To Top Of Rops | 13.7 ft in
|
|---|
| Rops/Fops | ROPS/FOPS meet ISO 3471:2008 and ISO 3449:2005 Level II standards
|
|---|
|
| Transmission |
|---|
| Transmission | 16 gal
|
|---|
| Transmission Type | Cat switched reluctance electric drive
|
|---|
| Peak Power Speed | 1,500 rpm
|
|---|
| Rated Speed | 1700 rpm
|
|---|
| Forward 1 (Virtual) | 4.3 mph
|
|---|
| Forward 2 (Virtual) | 7 mph
|
|---|
| Forward 3 (Virtual) | 13.8 mph
|
|---|
| Forward 4 (Virtual) | 20 mph
|
|---|
| Reverse 1 (Virtual) | 4.3 mph
|
|---|
| Reverse 2 (Virtual) | 7 mph
|
|---|
| Reverse 3 (Virtual) | 17.5 mph
|
|---|
|
| Technical Specs |
|---|
| Ground To Top Of Hood | 10.9 ft in
|
|---|
| B-Pin Height - Maximum Lift | 18 ft in
|
|---|
| Reach - Maximum Lift | 6.8 ft in
|
|---|
| Ground To Center Of Axles | 3.2 ft in
|
|---|
| Bore | 5.7 in
|
|---|
| Stroke | 7.2 in
|
|---|
| Oscillation Angle | 13 degrees
|
|---|
| Note | All non-road Tier 4 Final/Stage IV diesel engines are required to use: The machine has the flexibility to run on either ultra-low-sulfur diesel fuel (ULSD with 15 ppm of sulfur or less) or up to B20
|
|---|
| Raise | 8 s
|
|---|
| Dump | 2.2 s
|
|---|
| Lower Float Down | 3.5 s
|
|---|
| Rack Back | 4.5 s
|
|---|
| Lift/Tilt System - Circuit | EH-Positive Flow Control, Flow Sharing
|
|---|
| Tilt Cylinder - Stroke | 27 in
|
|---|
| Tilt Cylinder - Bore | 8.7 in
|
|---|
| Air Conditioning | The air conditioning system on this machine contains the fluorinated greenhouse gas refrigerant R134a (Global Warming Potential = 1430). The system contains 1.8 kg of refrigerant which has a CO2 equi
|
|---|
| Note (1) | The operator sound pressure level was measured according to the test procedures and conditions specified in ISO 6396:2008. The measurement was conducted at 70 percent of the maximum engine cooling fa
|
|---|
| Note (2) | Hearing protection may be needed when the machine is operated with a cab that is not properly maintained or when the doors or windows are open for extended periods or in a noisy environment.
|
|---|
| Note (3) | The machine sound power level was measured according to the test procedures and conditions specified in ISO 6395:2008. The measurement was conducted at 70 percent of the maximum engine cooling fan sp
|
|---|
|
